Smoke odor that keeps coming back after cleaning
We use thermal foggers and hydroxyl generators to treat the pockets a spray bottle can't reach, then test the air before we call the job done. If odor comes back, we re-treat at no charge.
Fire Damage Restoration Near Me in EDWARDS is the service you call when the flames are out but the damage is just starting. We pull soot off walls, neutralize smoke odor at the source, and dry the water firefighters left behind. Whether you're in Downtown Edwards or out near University Area, our local fire damage restoration in EDWARDS crew works fast to keep a small fire from turning into a mold and structural problem.

Fire Damage Restoration Near Me in EDWARDS is the full cleanup and repair process that starts the moment the fire truck leaves. It covers soot removal, smoke odor neutralization, water extraction from suppression efforts, charred structural repair, and HVAC decontamination. We use thermal imaging cameras and moisture meters to find damage you can't see, then HEPA air scrubbers and hydroxyl generators to clear the air. Every job is documented to NFPA 921 standards so your insurance adjuster has what they need.
Most EDWARDS homeowners call us after a kitchen fire, an electrical fire in the attic, or a bedroom fire that looked small until the smoke spread through the whole house. Soot residue etches into drywall and corrodes metal fixtures within 72 hours, and smoke odor penetration gets worse the longer it sits. That's why we treat every call as time-sensitive. If you need fire damage restoration near me EDWARDS California, we're set up to move the same day.
Every fire loss is different, but the core scope covers board-up, water extraction, drying, soot removal, odor treatment, and rebuild. Here's what's in the standard package and what gets priced separately once we've inspected.
Windows, doors, and roof openings get secured the same visit. Materials stay in place until the rebuild phase, so weather and pests stay out of the structure.
Standing water from suppression gets extracted, then air movers and dehumidifiers run 3 to 5 days. Daily moisture readings confirm the framing is dry before rebuild starts.
Soot sponges, degreasers, and HEPA vacuums used according to surface type. Walls, ceilings, cabinets, and fixtures get cleaned and sealed with smoke sealant primer.
Thermal fogging, ozone generators, and hydroxyl generators treat insulation, lumber, and ductwork. Follow-up testing confirms odor is neutralized, not masked.
Filters, ductwork, and the air handler get cleaned or replaced so smoke residue doesn't recirculate through the house after the job is done.
Drywall, lumber, insulation, and roofing shingles replaced to California Building Code specs. Permits and inspections handled by us, not handed off to you.
You call (833) 929-6186 and describe the fire. We ask about the room of origin, whether the power is off, and whether the roof or windows are open. A crew is dispatched with board-up materials and extraction gear. In most EDWARDS neighborhoods we're on site within 60 to 90 minutes.
We walk the house with a thermal imaging camera and moisture meter, mapping char, soot residue, and hidden water. You get a written scope with line items and photos before demolition. This is the document your adjuster works from, so we build it carefully.
Windows get boarded, the roof gets tarped, and standing water gets extracted. Air movers and dehumidifiers run for 3 to 5 days, monitored daily until framing reads dry. We don't start rebuild until the structure passes moisture checks.
Soot sponges handle dry soot on walls and ceilings. Wet soot on kitchen surfaces gets degreased first. Ductwork and HVAC filters are pulled and replaced, then duct sealing materials go in. Thermal fogging and hydroxyl generators run to neutralize odor in insulation and lumber.
Drywall, lumber, insulation, and roofing shingles go back to California Building Code specs. We prime with smoke sealant primer before paint so odor doesn't bleed through. The final walk covers every room with you, and we don't close the job until you sign off.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Finds hidden char in walls and ceilings and locates water from suppression that isn't visible to the eye.
Reads framing and subfloor moisture daily during drying. Rebuild doesn't start until readings drop under 16%.
Filters airborne soot and ash during demolition and cleaning so residue doesn't settle back onto clean surfaces.
Pushes odor counteractant chemicals into insulation, lumber, and wall cavities where smoke odor penetration lives.
Neutralizes odor in unoccupied spaces. We follow the manufacturer's clearance times before anyone re-enters.
Treats odor in occupied or sensitive spaces where ozone isn't appropriate, including homes with pets or plants.
Removes char and soot from framing and brick without the abrasive damage sandblasting causes.
A grease fire charred the range hood, stained the ceiling, and sent wet soot across the cabinets and into the living room. Suppression water sat in the subfloor for two days before the call.
We extracted 40 gallons of standing water, dried the subfloor to 12% moisture over four days, replaced the range hood and a section of ceiling drywall, and fogged the first floor twice. Odor testing came back clean on day nine.
Old wiring started a fire that charred three roof trusses and soaked the insulation. From inside the house it looked like a small scorch mark on the ceiling.
Thermal imaging found the full extent. We replaced three trusses, pulled and replaced 240 square feet of insulation, sealed the attic with smoke sealant primer, and re-ran the ductwork. The rebuild passed inspection on the first walk-through.
One unit caught fire and smoke spread into six adjacent units through shared ductwork. Property management needed documentation for each tenant's claim within a week.
We inspected all seven units, cleaned the shared HVAC, replaced filters and duct sealing materials, and wrote separate scopes for each tenant. All units were cleared within 11 days, and the property manager used the reports for six separate claims.
The fire is the obvious problem. The ones that follow it, smoke odor, hidden water, mold, and corroded fixtures, are what turn a two-week job into a two-month one. Here's what we fix and how.
Ask a pro →We use thermal foggers and hydroxyl generators to treat the pockets a spray bottle can't reach, then test the air before we call the job done. If odor comes back, we re-treat at no charge.
We extract standing water, set air movers and dehumidifiers, and monitor daily until framing reads under 16% moisture. Rebuild doesn't start until the structure passes.
We clean with soot sponges and degreasers matched to the surface, then seal with smoke sealant primer. Metal fixtures get treated before corrosion sets in.
We pull filters, clean or replace ductwork, and use duct sealing materials to close gaps. The system gets cleared before the rest of the house is cleaned.
Call a licensed California contractor that holds IICRC FSRT certification and can show you a written scope before work starts. Ask whether they handle board-up, drying, soot removal, and rebuild in-house or subcontract it out. We do all five with one crew, and we're on site in most EDWARDS neighborhoods within 60 to 90 minutes of your call.
The best local fire damage restoration company in EDWARDS is the one that documents the loss to NFPA 921 standards, dries the structure to under 16% moisture before rebuilding, and puts the scope in writing before demolition. Ask for IICRC FSRT and OCT credentials, a CSLB license, and proof of insurance. We carry all of them and walk you through the paperwork on the first visit.
Yes. We answer the phone around the clock, including holidays, because a fire loss gets worse every hour it sits. Board-up and water extraction happen the same night in most cases. Drying equipment runs 3 to 5 days after that, monitored daily. Call (833) 929-6186 any time and a real person picks up.
Typical 2026 pricing in this area runs $3,500 to $12,000 for a single-room fire, and $18,000 to $60,000 or more for a whole-house loss with structural rebuild. Square footage, char depth, water damage from suppression, and whether the HVAC system was contaminated are the biggest cost drivers. We give you a written scope before demolition so you know the number up front.
Smoke odor and soot residue get worse every hour they sit. Call (833) 929-6186 and a real person answers, day or night. We'll board up, dry out, and write the scope your insurance company needs. Licensed California contractor, IICRC-certified crews, and a written price before demolition starts.
Call Now (833) 929-6186 →If a fire has damaged your home or business, call us at (833) 929-6186. A live dispatcher answers 24 hours a day and sends a crew to your EDWARDS address, usually within 60 to 90 minutes for emergency calls. We will confirm a response window before we hang up.